Need help? 1.800.762.1142
Do not return to place of purchase.
W Dome and burner are extremely hot to the touch during operation. Never
touch the dome or burner while the heater is operating. The surface of
heater's emitter can reach temperatures approaching 1600ºF.
W Do NOT touch metal parts of heater until they have completely cooled
to avoid burns, unless you are wearing protective gear (pot holders,
gloves, BBQ mittens, etc.).
W Do NOT install or use in or on boats or recreational vehicles.
W When using, fire extinguishing materials should be readily accessible.
W Do NOT use heater in winds exceeding 10 mph (16.1 km/h).
W Do NOT leave a lit heater unattended. Keep children and pets away from
heater at all times.
W Do NOT place anything on the heater while the appliance is in operation.
W Keep sprinklers and other water sources away from burner and
controls.
W Do NOT hang clothing or other flammable materials either on or near
heater.
W Never cover the heater shroud while LP gas tank is enclosed.
W Do NOT attempt to move heater when in use. Allow the heater to cool
before moving or storing.
W LP gas cylinder must be properly disconnected and removed prior to
moving this heater.
W Storage of heater indoors is permissible only if the cylinder is
disconnected, removed from the heater and properly stored outdoors.
W Do NOT attempt to disconnect the gas regulator from the cylinder or any
gas fitting while the heater is in use.
W Always place your heater on a hard, non-combustible, level surface. An
asphalt or blacktop surface may not be acceptable for this purpose.
Replacement Parts
parts.BlueRhino.com /
1.800.762.1142
W Move gas hoses as far away as possible from hot surfaces and dripping
hot grease.
W Keep all electrical cords away from a hot heater.
W After a period of storage and/or nonuse, check for leaks, burner
obstructions and inspect for any abrasion, wear or cuts to the hose.
W If at any time you are unable to light burner and you smell gas, turn off
and wait 5 minutes to allow gas to dissipate before attempting to light
heater.
W Failure to not wait 5 minutes to allow the gas to clear if the heater does
not light may result in an explosive flame-up.
W Be careful when attempting to manually ignite this heater. Holding in
the control knob for more than 10 seconds before igniting the gas will
cause a ball of flame upon ignition.
W Avoid inhaling fumes emitted from the heater's first use. Smoke and
odor from the burning of oils used in manufacturing will appear. Both
smoke and odor will dissipate after approximately 30 minutes. The
heater should NOT produce thick black smoke.
W Use protective gloves when assembling this product.
W Do NOT force parts together as this can result in personal injury or
damage to the product.
W Death, serious injury or damage to property may occur if the above is
not followed exactly.
3