Heating Mode - EWT MaxiHC B/W Mode D'emploi

Heating Mode

Decrease Temperature
(Min 5ºC/41ºF)
Intelligent Eco Heat: The product will automatically regulate the room temperature
accordingly. In this mode the product operates at full power, however the output
of the product is automatically reduced and regulated as the room temperature
OR
approaches the desired level. This mode optimises energy use by calculating the
most efficient and effective way to achieve the desired temperature setting. The
desired room temperature can be adjusted at any time during operation by pressing
the appropriate key.
High Heat: In this mode, the appliance will operate at a high heat setting, the
appliance will automatically cycle at this setting to maintain the room temperature
setting. Fan speed is automatically set to Medium speed to boost heat output.
Low Heat: In this mode, the appliance will operate at a low heat setting, the appliance
will automatically cycle at this setting to maintain the room temperature setting.
Fan speed is automatically set to Low speed.
• If the temperature is set and is lower than the room temperature then the product will shut off.
The temperature will be flashing to indicate this. The product will stay in this state until the room
temperature lowers or the set temperature is increased higher than the room temperature.
Fan Speed
(Cooling Only)
Decrease Fan speed
Cycle through Fan speeds
Low Speed: This speed is designed to give a Low level of cooling effect.
Medium Speed: This speed is designed to give Medium cooling effect.
Turbo Speed: The 'highest velocity' setting is designed to give Maximum
cooling effect.
• Default Fan speed is Low. When only the Fan is running the segmented display cycles through
3 states to resemble a rotating fan blade.
When set to 5ºC the Frost Protect symbol appears. The product will cycle on and off to maintain
a temperature of approximately 5ºC to give a degree of protection against frost conditions.
Increase Temperature
(Max 30ºC/86ºF)
Cycle through
or
Heat modes
Increase Fan speed