EWT MaxiHC B/W Mode D'emploi page 6

Remote Bluetooth Pairing/Operation
The appliance can be controlled remotely using a smartphone or similar device. To facilitate
this remote operation it is necessary to first download the
both android and IOS devices and is available free from the Apple or Android App store. The
App is compatible with Android version 4.3 and above and IOS version 5 and above. Once
the App has been downloaded it is necessary to pair the appliance with the smartphone to
complete the remote setup. Please follow the steps shown below:
• On the smartphone, or other device, the product should be visible on the pairing screen, this will be a unique 6 digit
code but will always start with 'SZ', for example 'SZ6417'. Select this device and press connect to initiate pairing.
Press and hold for 2 seconds to
begin pairing.
Has the product previously been paired and
connected?
NO
Once Runback Timer and Heat are held for 2
seconds the Bluetooth Icon will begin to flash
slowly. You can now connect to the product
using a smart device.
When a device is found and is pairing the
Bluetooth icon will begin to flash quickly until
the device is paired whereby the icon will stop
flashing and stay on.
If product cannot connect after 60 seconds
product will exit pairing mode and the
Bluetooth icon will turn OFF.
CONNECTED
Press and hold for 2 seconds to exit
pairing mode and turn off Bluetooth icon.
app. The app is available on
Pairing : Slow flashing icon
YES
When turned on and Bluetooth was previously
set the product will automatically search for a
previously connected device for 60 seconds. If
previous device is not found after 60 seconds
Bluetooth will then exit pairing mode and the
Bluetooth icon will turn off.
If a connected device goes out of range the
product will try to reconnect for 60 seconds
and will then exit pairing mode and the
Bluetooth icon will turn off. When a previously
connected device comes back into range the
product will automatically repair.
Icon stays on solid.