Supplementary Information - EWT MaxiHC B/W Mode D'emploi

Supplementary Information

Control Panel Intensity
The control panel display remains visible at
all times and cannot be switched off. This
is for safety reasons to ensure the product
can remain visible in poor light conditions
(even if feature lighting is switched off).
The display reduces its intensity by 50%
after a 10s period of time. When a control
button is pressed it increases its intensity
temporarily.
Overheat protection
The heater is fitted with a temperature limiter.
If the air inlet or outlet grilles are restricted in
anyway the temperature limiter switches the
heater off automatically. To bring the heater
back into operation, remove the cause of
overheating then unplug the unit from the
electricity supply for a few minutes. When
the heater has cooled sufficiently reconnect
and switch on the heater.
Remote batteries
To insert or replace the battery remove the
battery cover on the rear of the remote.
Insert the button cell (CR/2025/3V) battery
with the positive terminal facing upwards.
Replace the cover.
Recycling
For
sold
Community. At the end of the
electrical products useful life it
should not be disposed of with
household waste. Please recycle
where facilities exist. Check
with your Local Authority or
retailer for recycling advice in
your country.
Batteries should be disposed of or recycled
in accordance with WEEE Directive 2012/19/
EU. Packaging should be recycled where
possible.
electrical products
within the European
After sales service
Should you require after sales service
please contact the retailer from whom the
appliance was purchased or contact the
service number relevant to your country on
the warranty card.
Please do not return a faulty product to us
in the first instance as this may result in loss
or damage and delay in providing you with
a satisfactory service.
In the interests of further development, the
appliance may be subject to constructional
or design changes without prior notice.
Please retain your receipt as proof of
purchase.
Model Identifier(s):
Heat output
Nominal heat output
Minimum heat output (indicative)
Maximum continuous heat output
Auxiliary electricity Consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat output/ room temperature control
Electronic room temperature control
Contact details
MaxiHC B/W
Pnom 2.5 kW
Pmin 1.35
kW
Pmax,c 2.5 kW
elmax 0.0 kW
elmin 0.0 kW
elSB 0.0005
kW
Yes
GDHVI
Dunleer,
Co. Louth,
Ireland.