Electrical Installation; Internal Call - Byron DIC-24815 Mode D'emploi

Instruction manual
ü A drill and suitable drill bit for the included screw plugs.
A. Position the provided mounting plate where desired.
B. Mark the screw positions with a pen.
C. Drill the necessary holes.
D. Insert the plugs.
E. (Optional) Pull the required cables through the cable gland if you
wish to use a power adapter.
F. Fasten the mounting plate with the screws.
NOTE: Before proceeding with below steps, make sure you have
paired the indoor unit with the outdoor unit (See chapter 3
Pairing).
G. Attach the outdoor unit to the mounting plate.
H. Fasten the screw at the bottom.
4.1

ELECTRICAL INSTALLATION

You can either connect the outdoor unit to an AC adapter or use
batteries for power.
4.1.1 Connecting the AC power adapter
To connect the terminals, you will need the following tool:
ü A small flat head screw driver.
A. On the outdoor unit: Loosen the terminal screws.
B. Insert the wires of the AC adapter with the cable shoes.
C. Fasten the terminal screws.
D. After wiring the outdoor unit: Plug in the AC adapter into a
compatible wall outlet.
4
4.1.2 Insert batteries
A. Slide off the battery cover at the front of the outdoor unit.
B. Install 3 'AAA' batteries following the polarity as shown.
C. Replace the battery cover.
5 Use
5.1 SET MELODY
Press the arrow buttons to set a melody.
5.2 SET RINGTONE VOLUME
Press the Ringtone button to set the ringtone volume.
5.3 TALK
When a visitor presses the call button of the outdoor unit, the indoor
unit will give a sound. Press the talk button on the indoor unit to
answer and talk to the person outside. Press again to end the
conversation.
5.4

INTERNAL CALL

When someone presses the talk button on the indoor unit, another
indoor unit will give a sound. Press the talk button to answer the call,
press again to end the call.