Threading Bobbin Case; Threading The Machine - Blaupunkt CASUAL 845 Manuel

Place bobbin into bobbin Place bobbin into bobbin
1
case. Make sure the thread case. Make sure the thread
unwinds in the direction of unwinds in the direction of
arrow.
Always thread your machine with the power off!

Threading Bobbin Case

Pull the thread into the bobbin
2
case slot.

Threading the Machine

Raise the take-up lever to its highest position by turning the
toward you. Raise the presser foot. Place the spool on th e
with thread c oming from the back of the spool.
1. Draw the thread into th read guide using both hands.
2. Draw the thread into the second (2) thread guide using both hands. thread into the second (2) thread guide using both hands.
3. While holding the thread near the spool, draw th e
1
tension area and then around the check spring holder tension area and then around the check spring holder .
4. Firmly draw the thread up and through the take- up lever from right to
left.
5. Draw the thread down and slip it into the needle bar thread guide.
6. Thread the needle eye from front to back.
NOTE: You may want to cut the end of the thread with a pair of sharp scissors
for easier ne edle threading. Switch on the power after threading the machine and edle threading. Switch on the power after threading the machine and
bobbin. You are now ready to sew.
33
Draw the thread under the tension Draw the thread under the tension
3
spring and into the delivery eye. spring and into the delivery eye.
* L eave about 10cm (4 inches) of free eave about 10cm (4 inches) of free
thread.
the balance wheel
e spool pin as shown,
read guide using both hands.
e thread down into the
up lever from right to
needle bar thread guide.
thread with a pair of sharp scissors
EN