Setting Spool Pin; Removing Or Inserting The Bobbin Case; Winding The Bobbin - Blaupunkt CASUAL 845 Manuel

Einstellen Garnrollenstift
EN
Ziehen Sie den Garnrollenstift.
Pull out the spool pin. Insert the
shorter side of spool pin into the
Legen Sie die kürzere Seite
machine.
des Garnrollenstift in die hine.
Cross the cotton in a figure of
eight for good tension
Draw the thread from the spool. Guide the thread around the bobbin winder thread guide.
Insert the thread through one of the holes in the bobbin Insert the thread through one of the holes in the bobbin from the inside to the outside.
Put the bobbin on the bobbin winder spindle, and push it to the right. This will disengaged the machine and engage the spooli Put the bobbin on the bobbin winder spindle, and push it to the right. This will disengaged the machine and engage the spooli ng facility. Put the bobbin on the bobbin winder spindle, and push it to the right. This will disengaged the machine and engage the spooli
With the free end of the thread held in your hand, depress the foot control. Stop t With the free end of the thread held in your hand, depress the foot control. Stop the machine when it has made a few turns, and cut the thread
close to the hole in the bobbin. Depress the foot control again. close to the hole in the bobbin. Depress the foot control again.
When the bobbin is fully wound, it will stop automatically. When the bobbin is fully wound, it will stop automatically.
Return the bobbin winder to its original position by moving the spin Return the bobbin winder to its original position by moving the spin dle to the left, and cut the thread.

Setting spool pin

Removing or Inserting the Bobbin Case

Removing or Inserting the Bobbin Case
Open the hook cover. Open the hook cover.

Winding the Bobbin

spool. Guide the thread around the bobbin winder thread guide.
Switch off the machine while doing this! Switch off the machine while doing this!
Raise the needle by turning the
balance wheel toward you.
Take out the bobbin case by holding
the latch.
he machine when it has made a few turns, and cut the thread
32
Inserting the Bobbin Case Inserting the Bobbin Case
When inserting the bobbin case, When inserting the bobbin case,
place the horn into the recess of the place the horn into the recess of the
hook race. hook race.
Switch on the machine. Switch on the machine.