Drawing Up Bobbin Thread; Balancing Needle Thread Tension - Blaupunkt CASUAL 845 Manuel

EN
1
Raise the presser foot and hold the needle
thread lightly with your left hand.
The needle thread and the bobbin
thread should interlock in the
center of two layers of fabric in
straight stitch seams.

Drawing up Bobbin Thread

2
Turn the balance wheel slowly towards you
with your right hand until th e needle goes
down and continue turning balance wheel
until the take-up lever is at its highest
position. Lightly draw up the needle thread
forming a loop of the bobbin thread.

Balancing Needle Thread Tension

The needle thread is
too tight
Setting mark
Loosen
Tinghten
Set the desired Loosen the needle thread
number of the tension by moving the
thread tension dial dial to a lower number
at setting mark.
Pull 15cm (6") of both threads back and
3
under the presser foot.
The needle thread ist
to loose
Tighten the needle thread
tension by moving the
dial to a higher number.
34
Thread Tension for Zigzag
Sewing
To obtain better zigzag stitches,
the upper tension should be
slightly lower than in the case of
straight sewing. The upper thread
should appear slightly on the
reverse side of the fabric.