Adjusting Stretch Stitch Balance; Reverse Stitch Control; Darning Plate; Left Needle Position - Blaupunkt CASUAL 845 Manuel

Stitch length
EN
Stitch Length Control

Reverse Stitch Control

As long as you keep the reverse
stitch control depressed, the
machine sews backwards.

Adjusting Stretch Stitch Balance

Adjusting Stretch Stitch Balance
To select Stretch Stitches, set this control at SS position.
Setting mark
In stretch stitch sewing, Stitch Length Control should be in
the Center position between - and + (SS position) for most
materials. Depending upon the type of fabric used. You
may need to adjust this control to match forward stitches of
stretch sewing with reverse motion stitches.
To shorten stretch stitches, turn the control slightly toward
"-" To lengthen, turn toward "+"
Reverse Stitch Control

Darning Plate

Darning Plate
To Put on the Darning Plate: To Put on the Darning Plate:
1. Position the darning plate Position the darning plate
with the 3 pins on the bottom. the 3 pins on the bottom.
2. Fit the darning plate pins into Fit the darning plate pins into
the needle plate holes. The the needle plate holes. The
feed dogs will show through feed dogs will show through
the darning plate holes. the darning plate holes.

Left Needle Position

Stitch selector
Use Left Needle Position for more
control while topstitching or edge
stitching difficult fabrics.
NOTE: Use only zigzag presser
foot for Left Needle Sewing
36
+ .SS. -
Smocking stretch
Rick rack stretch