Care And Maintenance - Blaupunkt BP-GIKLED11 Mode D'emploi

BP-GIKLED11
Choose either the auto or timer mode as you cannot use them simultaneously.
For best results, turn off other light sources and prevent from installing the appliance in the draught.
5.3. Sticky Pads
1. Switch of the appliance and disconnect from the mains.
2. Remove the protective layer of the sticky pad.
3. Apply it at the bottom of the storage tray. Replace when covered with bugs.
4. Close the tray and reconnect the appliance to the mains.
6. Troubleshooting
Appliance does not start
Appliance does not light

7. Care and Maintenance

Storage
Store the appliance and its accessories in a clean and dry area.
Cleaning
The cleaning frequency depends on the intensity of use. Check the tray of the device at least once a week.
Clean more often if necessary.
Before starting any cleaning or maintenance activities, unplug the appliance from its power source and let it
cool down.
Wipe all exterior surfaces of the appliance clean with a soft cloth dampened with a soap and water solution.
Do not immerse or submerge any part of the appliance in water or any other liquid. Never use solvents or
cleaning agents containing petroleum (petrol, kerosene, oil), paint thinner, turpentine, alcohol, or ammonia.
1. Switch off the device and disconnect from the power supply.
2. Take out the fan and clean with a dry cloth.
3. Clean the container and trap – rinse with water if necessary.
BP-GIKLED11.indd 5
Problem
Power supply not connected well
On-off button not pressed
Power supply not connected well
PCB board is damaged
Noisy fan Foreign objects in the fan
Reason
Light source cannot be replaced;
Light is damaged
5
Possible solution
Reconnect the power supply
Press the on-off button
Reconnect the power supply
scrap the appliance
PCB Board cannot be replaced;
scrap the appliance
Clean the fan
12/01/2021 15:53:56