Bosch CM12 Consignes De Fonctionnement/Sécurité page 36

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 36
pROBlEM
Blade hits table.
Angle of cut not accurate.
Cannot move miter adjustment.
Head assembly will not fully
rise or blade guard will not fully
close.
Blade binds, jams, burns wood.
Rough cuts.
Tool vibrates or shakes.
*Always follow manufacturer instructions*
Troubleshooting
Troubleshooting Guide - General
1. Misalignment
1. Misalignment
1. Lock knob tightened/detent
engaged.
2. Sawdust under table.
3. Blade interferes with fence.
1. Part failure.
2. Pivot spring or guard spring
not replaced properly after
service.
3. Cover plate not tightened
after replacing blade.
4. Sawdust accumulation.
1. Improper operation.
2. Dull blade.
3. Improper blade.
4. Bent blade.
1. Saw blade not round.
2. Saw blade damaged.
3. Saw blade loose.
4. Other.
*AAA Rent-All 225-291-1356*
CAUSE
- Authorized service.
- See Adjustments section.
- Loosen lock knob/move out
- Vacuum or blow out dust.
- Authorized service.
- Authorized service.
- Authorized service.
- See Blade Installation page
- Clean head assembly.
- See cleaning page 34
- Replace or sharpen blade.
- Replace with 12" diameter
- Replace blade.
- Replace blade.
- Replace blade.
- Tighten blade screw.
- Authorized service.
-36-
CORRECTIVE ACTION
of detent.
Wear eye protection.
10 & 11.
blade designed for the mate
rial being cut.