Bosch CM12 Consignes De Fonctionnement/Sécurité page 31

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 31
Auxiliary fence - Using an Auxiliary Fence when cutting Crown molding flat on the table will reduce
splintering of your workpiece and movement of small cut-off pieces. Remove the saw's sliding fences
(see page 21) before attaching the auxiliary fence.
Build auxiliary fence by following pattern below - Material: 3/4" x 1-1/2" wood.
Add 4 holes as dimensioned on pattern -or- Add holes following the next steps:
1) Cut wood to the outside dimensions shown and temporarily attach to saw's stationary fence using
two C-clamps.
2) Use 1/4" drill bit to drill first through existing holes in the rear of the stationary fence and then
through the wood.
3) Remove wood, countersink the front of the wood and permanently attach to saw's fence with hard-
ware shown below.
5/16 Dia. (4)
3-1/8 "
7-1/4
Nut (need 4)
Flat Washer (need 4)
Stationary
Fence
*Always follow manufacturer instructions*
Saw Operations
Crown Molding Auxiliary fence
"
Saw Base
*AAA Rent-All 225-291-1356*
21-3/4 "
"
5/16
FIG. 43
FIG. 44
New Auxiliary Fence
5/16" Hole Through
1/2" Countersink
1/4" Flat Head Machine Screw x 2-1/2" Long
(need 4)
Top of Base
and Table
Note: The Stationary Fence is permanently
attached to the Saw Base (do not remove)
-31-
"
3-1/8
7-1/4 "
Board: 3/4" Wide x 1-1/2" High