Menu Settings - LaserLiner CondenseSpot Plus Mode D'emploi

7
Thermal bridge mode
In relation to buildings, the term thermal bridge refers to an area, e.g. an inside wall,
at which heat is transferred outwards faster than at the rest of the inside wall. When
viewed from the inside, the temperature of this area is lower than the surrounding
areas and when viewed from outside higher than the surrounding areas. This often
indicates faulty or inadequate insulation.
For this purpose, the CondenseSpot Plus compares the ambient temperature with the surface temperature.
If there are large differences in both temperatures, the device will trigger warnings in 2 stages: „CHK" is
displayed in borderline cases or the display lighting changes to „blue" or „red" to indicate the differences
are very large.
Ambient temperature:
20°C
No thermal bridge
8

Menu settings

ON
SET
Cont LOK
FAC
Ambient temperature:
20°C
Possible thermal bridge,
continue checking area
°C
Continuous measurement
By selecting the „Cont LOK" function, continuous measurements can
be carried out without having to permanently press the trigger button.
ON
Continuous measurement starts by briefly pressing the trigger button.
A lock symbol appears on the display. The value is held (HOLD) by
pressing the button again.
Factory setting
The „FAC" function resets the device to the factory setting.
ON
CondenseSpot Plus
Ambient temperature:
20°C
Thermal bridge,
display lights blue with
acoustic signal
°F
SET
OFF
SET
OFF
SET
Ambient temperature:
12°C
Thermal bridge,
display lights red with
acoustic signal
Confirm
Confirm
SET
3 sec
Confirm
15
EN