Important Safety Advice - EWT Clima 902TLS Mode D'emploi

Dear Customer,
Please read the following information carefully before using the appliance for the
first time for your own safety and to ensure correct use.
Attention! The appliance may only be used for normal domestic use and not for
industrial purposes.

Important safety advice

The appliance must only be used as described in the instructions for use! Use for
any other purpose is forbidden! Any damage resulting from improper use and non-
observance of the safety information will invalidate any liability and warranty!
All liability is disclaimed for any frost damage caused by a heating capacity that
is insufficient for the room size, bad heat insulation of the room, incorrect use or
force majeure (e.g. power failure).
Only connect the appliance to A.C. mains as specified on the rating plate!
Never touch live parts! Danger to life!
Never operate the appliance with wet hands! Danger to life!
Check the power cord regularly for damage.
The appliance should not be used in areas which are a fire risk, such as garages,
stables, or wooden sheds.
The appliance must be placed in a way that the control elements cannot be touched
by persons who are in bath, shower, or any other water-filled receptacle.
Do not use the appliance in rooms with bath, shower or swimming pool or in the
vicinity of wash basins or water connections!
Important – Do Not use as a hairdryer.
DO NOT use the heater on deep pile carpets or the long hair type of rugs, or less
than 750mm (30") away from any overhanging surface. Keep combustible materials
such as drapes and other furnishings clear from the front, sides and rear of the
heater. Do not use heater to dry your laundry.
Never use the appliance if the appliance or cord is damaged. Risk of injury!
If the power cord or if the appliance is damaged to the extent that electrical parts
are exposed, disconnect it immediately from the mains and see your authorised
retailer!
Improper repairs can expose the user to considerable danger.
Do not store or use any flammable materials or sprays in the vicinity of the appliance
when the appliance is in use. Fire hazard!
Do not use the appliance in flammable atmospheres (e.g. in the vicinity of
combustible gases or spray cans)! Explosion and fire hazard!
Important! Do not insert any foreign objects into the appliance openings! Risk of
injury (electric shock) and damage to the appliance!
The appliance air inlet and outlet openings must not be obstructed in any way!
Place the appliance so that it cannot be touched by accident. Risk of burns!
Do not place any items of clothing, towels or similar on the appliance to dry!
Overheating and fire hazard!
The appliances is not suitable for connection to permanent wiring!
The appliance is not intended for use by young children or infirm persons without
supervision!
Young children should be supervised to ensure that they do not play with the
appliance!
The socket-outlet must be accessible at all times to enable the mains plug to be
disconnected as quickly as possible!
The appliance is not suitable for animal breeding purposes!
The instruction leaflet belongs to the appliance and must be kept in a safe place.
When changing owners, the leaflet must be surrendered to the new owner!
The appliance may only be opened up and repaired by authorised qualified
personnel.
If the supply cord is damaged it must be replaced by the manufacturer or service
agent or a similarly qualified person in order to avoid a hazard.
WARNING : In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching device,
such as a timer, or connected to a circuit that is regularly switched on and off by
the utility.
The heater carries the Warning symbol, indicating that it must not be
covered. The appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning the
use of the appliance by a person responsible for their safety!
Packaging
After unpacking the appliance, check the same for transport damage and the
contents for completeness! In the event of damage or an incomplete delivery,
contact your authorised retailer!
Do not discard the original box! It can be used for storage and dispatch to avoid
transport damage!
Dispose of the packaging material in a proper manner! Plastic bags should be kept
away from children!
Power cord
Only use an approved extension cord that is suitable for the appliance rating!
Position the power cord so that it does not pose a tripping hazard and possibly
cause the appliance to be knocked over.
The power cord must not come into contact with hot appliance parts!
Never pull the plug out of the socket at the cord!
Never move the appliance by pulling at the cord or use the cord for carrying
purposes!
Do not coil the cord around the appliance! Do not use the appliance with the
cord coiled!
This applies particularly if a cable drum is used.
Do not crush the cord or drag it over sharp edges. Do not place it over heated
hotplates or naked flames!
VERY IMPORTANT ADVICE
Normal use of your fan heaterin areas which have high levels of fluff, dust or hair (e.g.
bedrooms/dressing areas/hair salons) especially on solid/lino covered floors, will result
in the accumulation of these inside the heater at the back of the element. If left to
build up, it will eventually result in the safety cut-out operating to protect you and the
heater from the danger of the product overheating! It is therefore critical that you use
a vacuum cleaner to regularly blow out and clean any accumulation from the heater!
(See CLEANING section for detailed instructions)
Positioning the heater
Always ensure that the heater is stood on a firm, level base near to, but not directly
beneath, a suitable mains supply socket.
Ensure that curtains and furniture are not positioned close to the chosen position, as
this would create a potential fire hazard.
See also 'Important Safety Advice' .
Using the heater
The mains neon (see Fig. 1) will light up to show that the heater is connected to the
mains supply.
Heat control – see Fig. 2
The heat control positions are as follows:
O - Off
- Cool Blow *
I - Half heat output
II - Full heat output
Thermostat control – see Fig. 3
The heat output is controlled by the thermostat, according to the room temperature.
Turn the knob to maximum setting initially. When the room is warm enough, reduce
the setting slowly until the heater just clicks off.
The heater will now cycle on and off to maintain your selected room temperature.
NOTE: If the heater does not come on when the thermostat is set to a low number, this is
normally because the room is warmer than the thermostat setting and is not a fault.
* When the heat control is set to for Cool Blow, set the thermostat control to max.
position.
In accordance with room size, position
a temperature of approximately 5°C to help protect against frosty conditions.
Important Notes
Although this heater is manufactured to comply with the relevant safety standards,
certain types of carpets could become discoloured by the temperatures under a portable
heater. If you are concerned about this, we recommend that you contact the carpet
manufacturer for guidance. Alternatively, stand the heater on a suitable base to shield
the carpet – call our Helpline for further advice.
You may notice some parts of the element appearing to glow hotter or redder from
time to time because of the variable airflow through the heater. This does not cause
a safety hazard.
The heat outlet grille may become discoloured with use – this is caused by airborne
pollution and is not a fault.
Safety – overheat protection
For your safety, this appliance is fitted with a thermal cut-out. In the event that the
product overheats, the cut-out switches the heater off automatically. To bring the
heater back into operation, remove the cause of the overheating, then unplug or
turn off the electrical supply to the heater for a few minutes. When the heater has
cooled sufficiently, re-connect and switch on the heater.
Cleaning and User Maintenance
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE
HEATER.
Allow the heater to cool, then wipe with a dry cloth to remove dust and a damp cloth
(not wet) to clean off stains. Be careful not to allow moisture into the heater.
To ensure continued normal operation of your heater, you must regularly clean out
any accumulation of particles from inside the heater! This is best achieved by using
your vacuum cleaner in Blow Mode to blow air into the heater through the front air
outlet to dislodge any accumulated matter from the back of the element (If it does not
have this function, then blowing hard yourself will have the same result). Then use the
vacuum in Suction Mode to suck out the loose particles through the top and bottom
air inlets. This will serve to clean these areas also. For normal surface cleaning, do not
use detergents, abrasive cleaning agents or polish of any kind on the heater. Wipe with
a dry cloth to remove dust and a damp (not wet) cloth to clean off stains. Be careful not
to allow moisture into the heater.
Recycling
For electrical products sold within the European Community. At the end of
the electrical products useful life it should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local Authority
or retailer for recycling advice in your country.
After Sales Service
All repairs must be referred to authorized personnel! Refer all repairs to an authorized
retailer!
Important! Any tampering with the appliance will invalidate the warranty.
Repairs carried out improperly and by unqualified persons may have serious
consequences for the user.!
will turn the heater on and off to maintain