Table des Matières
Publicité
DESCRIPTION
EN
KNOW YOUR EDGER ATTACHMENT (Fig.A)
1. End Cap
2. Edger Shaft
3. Blade Guard
4. Blade
5. Depth Adjusting Knob
6. Guide Wheel
7. Hex Wrench
8. Multi-Functional Wrench
9. Depth Adjusting Guide Bar
10. Debris Flap
11. Cotter Pin
12. Screw to lock guide plate in place
13. Guide Plate
ASSEMBLY
WARNING:
If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended for use with this
edger. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possibly
serious personal injury.
WARNING:
Do not adjust the blade guard. The
blade guard has been set at the factory so that the arrow
on the blade guard and the open side point away from the
operator. This ensures that cuttings and other debris are
directed away from the power tool and the operator.
CONNECTING THE EDGER ATTACHMENT TO THE
POWER HEAD
This edger attachment is designed for use with EGO 56V
Lithium-ion Power Head PH1400E.
See " INSTALLING AN ATTACHMENT TO THE POWER
HEAD " section in the power head PH1400E operator's
manual.
OPERATION
WARNING:
Do not allow familiarity with this product
to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
8
EDGER ATTACHMENT — EA0800
WARNING:
Always wear eye protection, along with
hearing protection. Failure to do so could result in objects
being thrown into your eyes and other possible serious
injuries.
APPLICATIONS
You may use this product for the purpose listed below:
◾
Edging around walkways, curbing, flower beds and other
similar areas.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse.
Before each use check for damaged/worn parts
Check the blade, guard and front-assist handle and
replace any parts that are cracked, warped, bent, or
damaged in any away.
WARNING:
To prevent serious personal injury,
remove the battery pack from the tool before servicing,
cleaning, changing attachments or removing material
from the unit.
USING THE EDGER ATTACHMENT WITH POWER HEAD
WARNING:
Dress properly to reduce the risk of
injury when operating this tool. Do not wear loose clothing
or jewelry. Wear eye and ear/hearing protection. Wear
heavy, long pants, boots and gloves. Do not wear short
pants or sandals or go barefoot. Wear a face mask or dust
mask in dusty locations.
WARNING:
Clear away all obstacles and solid
objects from the work area.
For safe and better operation, put on the shoulder strap
across the shoulder. Adjust the shoulder strap in a
comfortable operating position.
Hold the edger with your right hand on the rear handle
and your left hand on the front-assist handle. Keep a firm
grip with both hands while operating the tool. The edger
should be held at a comfortable position with the rear
handle about hip height (Fig. B).
WARNING:
The shoulder strap is also a quick
release mechanism in hazardous situation. When
emergency occurs, take it off from your shoulder
immediately, no matter what way the strap is in.
After each use, clean the edger
See the MAINTENANCE section for cleaning instructions.
ADJUSTING DEPTH OF CUT
1. Stop the motor and remove the battery pack.
Publicité
Table des Matières
