Focal SIB EVO Manuel D'utilisation page 13

SIB EVO - SIB EVO DOLBY ATMOS®
User Manual
13
B - Sib Evo in a 5.1 Home Cinema Setup
1- Centre loudspeaker:
To use the Sib Evo satellite loudspeaker as a centre loudspeaker, unscrew the rubber base from the
loudspeaker, stick the slip-resistant sticker in place (as shown in fig. B1) and position the loudspeaker
horizontally central to the base (fig. B2). The centre loudspeaker must be positioned the same
distance away from the front left and right loudspeakers. Turn the logo clockwise until it appears
upright (figs. B2 and B3).
2- Adjusting the angle of inclination:
Sib Evo is supplied with the base pre-mounted.
However, you can adjust the angle of inclination of the loudspeaker according to your listening point.
To adjust the angle of inclination, simply loosen the screw under the base and adjust as required as
shown above. Once you have the desired angle, tighten the screw to secure the loudspeaker to its
base (fig. A3).
C - Sib Evo in a 5.1.2 Dolby Atmos® Home Cinema Setup
The 5.1.2 pack features two Sib Evo Dolby Atmos® satellite loudspeakers certified by Dolby. These
satellite loudspeakers are equipped with two speaker drivers, one of which is fired towards the ceiling
to provide Dolby Atmos® effects. Dolby Atmos® technology offers true 3D sound by including a verti-
cal dimension, that's to say the propagation of sound waves emitted from a new source: the ceiling.
This new dimension provides even more precision and realism for a multichannel experience worthy
of cinemas (figs. C1 et C2).
1- Centre loudspeaker:
To use the Sib Evo satellite loudspeaker as a centre loudspeaker, unscrew the rubber base from the
loudspeaker, stick the slip-resistant sticker in place (as shown in fig. B1) and position the loudspeaker
horizontally central to the base (fig. B2). The centre loudspeaker must be positioned the same
distance away from the front left and right loudspeakers. Turn the logo clockwise until it appears
upright (figs. B2 and B3).
2- Adjusting the angle of inclination:
All the loudspeakers in the Sib Evo packs are supplied with their bases pre-mounted.
The Sib Evo Dolby Atmos® loudspeaker is already mounted to its base according to Dolby Atmos®
recommendations.
However, you can adjust the angle of inclination of the loudspeaker according to your listening point.
- For a listening point less than 6.5 feet away (2m): tilt the loudspeakers back.
- For a listening point more than 8 feet away (2.5m): tilt the loudspeakers forward.
To adjust the angle of inclination, simply loosen the screw under the base and adjust as required as
shown above. Once you have the desired angle, tighten the screw to secure the loudspeaker to its
base (fig. A3).
CAUTION: with a Dolby Atmos® installation, it is advised not to have any obstacles (shelves, lights, etc.)
less than 3 feet (1m) above the Sib Evo Dolby Atmos® loudspeaker that could impede the reflection of
Dolby Atmos® sound off the ceiling.