Parts Provided - Fellowes Levado Mode D'emploi

SAFETY INSTRUCTIONS/WARNING
WARNING: IMPORTANT SAFETY INSTRUCTIONS – Read Before Using!
• CAUTION: Lift hazard! Two people are required to move desk. Serious injury may occur.
• DO NOT EXCEED MAXIMUM STATED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY
DAMAGE MAY OCCUR.
• Do Not operate table if any part is damaged or defective.
• Do Not place obstacles in the desk's path.
• Do Not place objects under the desk that are taller than 610mm (24").
• Make sure the desk has proper clearance on all sides (at least 25mm (1")) to all surrounding walls and objects.
• Do Not sit or stand on the desk.
• Do Not disassemble the legs, control box or controller. Serious injury may occur.
• Ensure all cable lengths are long enough to accommodate all changes in height and follow cord routing
instructions in this manual. Failure to follow these instructions may result in equipment damage or personal
injury.
• Keep liquids away from all electrical components. Only clean electrical components with a dry cloth.
• For indoor use only.
• Keep power cable away from sources of heat.
• Unplug desk before moving or servicing.
• Remove all equipment and accessories from the desk before moving.
• Keep children away from moving parts and underneath the desk.

PARTS PROVIDED

A Base x1
B Clamp x2
A
C Handset x1
D Power cable x1
E Cable Tray x1
F Cable Management x4
G 5mm Allen Key x1
H M6 Phillips round head screw x14
C
I M3 Phillips round head screws x2
J Clamp Covers x2
Additional Tools Required
Phillips Screw Driver
F
2
ENGLISH
Levado™ Height Adjustable Desk Base
Maximum Weight Including Table Top
≤ 100 kg
≤ 220 lbs
Accomodates table tops with the following dimensions:
• Width: 1187 - 1816mm
• Depth: 700 - 800mm
• Thickness: 19 - 31.75mm
B
D E
G H I J
INSTALL OPTION 1 - CLAMPS
STEP 1
Unboxing
• Open box from the top.
• Ensure levers on base are in the upright position.
• Fold out legs until they click. WARNING: Pinch Point! Keep hands
and objects clear when lifting legs.
• Lock legs into place by pushing down on levers.
• Optional: If legs need to be folded, ensure lever is in the upright position
and power is unplugged. Pull out pin and carefully guide legs to folded
position.
• Using two people, flip the base upright.
• The base arrives adjusted for 1600mm (63") wide tables. If your table is
not 1600mm (63") wide you will need to adjust the base width 1187 –
1816mm (47" - 71.5"). See step 1B, otherwise move on to step 2.
STEP 1B - Only required if table is not 1600mm (63") wide
Adjust the cross channels to their final lengths
• Using two people, place table face down on a soft, clean surface and place
base on table.
• Use the 5mm Allen key to loosen the (8) set screws on the inward side of the
cross channels.
• Expand or contract the cross channels until flush with both ends of the desk.
Free cables as necessary to allow the frame to adjust.
• Once properly adjusted, use the 5mm Allen key to re-tighten the set screws
(8 total).
• Using two people, flip the base only upright.
3