Accessory Installation - Fellowes Levado Mode D'emploi

STEP 2
Adjust the position of the frame before attaching it to the table
• Using two people, place the table top on the base.
• Check that the table top supports on each side are flush to both ends of the
desktop and align to the predrilled holes on the desktop.
• The rear cross channel will be 240mm (9.5") for 800mm (31.5") Depth Tops
from the rear of the table.
STEP 3
Clamping base to table
• Slide clamps on each side of the table.
• On each clamp, tighten the (2) thumb
screws until each click.
INSTALL OPTION 2 - HARDWARE
STEP 1
Preparing for installation using two people
• Place table face down on a soft, clean surface.
• Ensure levers on base are in the upright position.
• Fold out legs until they click, WARNING: Pinch Point! Keep hands and
objects clear when lifting legs.
• Lock legs into place by pushing down on levers.
• Optional: If legs need to be folded, ensure lever is in upright position and
power is unplugged. Pull out pin and carefully guide legs to folded position.
• Lift base out of box and place on table.
• The base arrives adjusted for 1600mm (63") wide tables. If your table is not
1600mm (63") wide you will need to adjust the base width 1187 – 1816mm
(47" - 71.5"). See step 1B, otherwise move on to step 2.
4
STEP 1B - Only required if table is not 1600mm (63") wide
Adjust the cross channels to their final lengths
• Use the 5mm Allen key to loosen the (8) set screws on the inward side of the cross channels.
• Expand or contract the cross channels until flush with both ends of the desk. Free cables as
necessary to allow the frame to adjust.
Rear
240mm (9.5")
• Ensure proper alignment to predrilled holes on the desktop.
• Once properly adjusted, use the 5mm Allen key to re-tighten the set screws (8 total).
Front
STEP 2
Adjust the position of the frame before attaching it to the table.
• Check that the top supports on each side are flush to both ends of the desktop and align to the
predrilled holes on the desktop.
• The rear cross channel will be 240mm (9.5") for 800mm (31.5") Depth Tops from the rear of
the table.
STEP 3
Attach base to the table
• Use the M6 Phillips round head screws (8 total required) and a Phillips screwdriver.
• The screws fit through guides in the top of the supports. Ensure proper alignment with predrilled
holes on the desktop.
• Using two people, flip the Base and Table upright.
• Attach clamp covers to each side. Start by placing the smaller piece on the inside of the clamp
bracket. Align the larger piece and apply pressure to secure.

ACCESSORY INSTALLATION

STEP 1
Cable Management
• Partially drive (4) Philips Head screws into the pre-drilled holes located towards the back of
the table.
• Hook the cable tray key slots onto the screws and slide the tray to lock it in place. (Note: the
open end of the cable tray should face the back of the table.)
• Tighten the (4) Philips Head screws to secure the cable tray.
• Use the additional provided cable management as needed.
• Cables must not interfere with table operation.
• Cables must not interfere with the user.
Rear
240mm (9.5")
Front
Rear
Front
5