Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
18. Locate factory drilled holes at bottom right corner of
rear panel. Align water valve bracket with factory drilled
holes. You may have to bend the metal tubing slightly
out of the way. Use a power drill with a Phillips® head
bit to drive two self tapping screws (4) through bracket
and into cabinet.
Water Valve (10)
Water Valve (10)
NOTE
Clean back of cabinet with a commercial household
cleaner, ammonia or alcohol before applying plastic
clamps to water tubing.
Factory
Punched
Holes
Screw (4)
OR
Factory
Punched
Holes
Screw (4)
Figure 14
19. Secure plastic water tubing to rear of cabinet with two
plastic clamps (9).
Figure 15
Plastic Clamp (9)
20. Punch out cutout on access cover to allow for water
valve (interior condenser models only).
21. Remount access cover (interior condenser models only)
and condenser, if it was pulled out of the way because
of space constraints.
6
Figure 16
Cutout
Sound Baffle
Publicité
Table des Matières
