Frigidaire IM116000 Instructions D'installation page 4

9. Push tube seal (12) over threads (Figure 5). Push
plastic water supply tubing (3) into water inlet tube (11)
as far as it will go and finger tighten nylon compression
nut onto threaded end of inlet tube. Tighten another ½
turn with a wrench. DO NOT over-tighten.
(11) Water Inlet
Tube
(3) Water
Tubing
10. Push water inlet tube (11) through small hole where
Installation label was (Figure 6). Rotate while inserting
tube until flat surface of inlet tube is tight against back
of refrigerator.
11. Install adjustable leveling bracket (7) on bottom of Ice
Maker (1) with screw (6) (Figure 7). DO NOT tighten
bracket. It will be tightened later in this procedure.
Leveling
Bracket (7)
Screw (6)
12. Start two, long, Ice Maker mounting screws (5) into
freezer wall where plugs were removed in Step 4. Turn
each screw clockwise five turns (Figure 8).
(12) Tube Seal
Figure 5
Figure 6
of Ice Maker (1) with screw (6). DO NOT tighten
bracket. It will be tightened later in this procedure.
Figure 7

NOTE
It requires the use of both hands to hook up and secure
the Ice Maker to the freezer wall. DO NOT let the Ice
Maker dangle free after the wiring harness is plugged
into the connector on the back freezer wall.
13. Connect wiring harness into connector mounted on the
back freezer panel, just to the left of where the water inlet
tube comes through. The harness connector is keyed so it
will only fit one way. Next, slide Ice Maker connector cover
over connector, noting the orientation in Figure 9. (Snap
on top, hook on bottom). The Ice maker connector cover
can then be snapped into place into the back panel or
slid up tight to back panel depending on which version of
back panel you have (see note below). Then, mount Ice
Maker to the two screws (5) you started earlier from Step
12. (See figure 10.) Tighten screws. Make sure water inlet
tube (11) is sitting inside fill cup.
Figure 7
Snap Snap
Ice Maker
Connector
Cover
Hook

NOTE
If your back
cover looks like
(A) proceed to
installing ice maker.
If your back cover
looks like (B),
break off snap and
hook on connector
cover using pliers,
then proceed to
installing ice maker.
4
Figure 8
(5) Ice Maker
Mount Screws
Wire
Harness
Connector
Cover Slides
Forward
Figure 9
A
Back Covers
B