Klarstein MUNDSCHENK Mode D'emploi page 20

EN
20
DISPLAY AND SETTINGS
Manual Mode Setting
1 Switch on the power switch, then press the MANUAL button.
2 TEMP is for Temperature setting, POWER is for Wattage setting, TIMER is for session
timing. All 3 of these must be set before machine will start. These can be set in any order.
3 Press START button when all 3 settings have been made, and the manual session
will start.
4 The default boiling temperature is 100 °C in our program, the timer will not be
triggered if temperature does not indicate 100°C. In this case, please put the cover
on for 1-2 minutes (or see below) to achieve 100°C on the display.
5 If the machine starts to boil, but shows a lower temp on the display, make the
following adjustment to set the temp at 100°C and trigger the timer.
6 Press „-" and „+" button together until the display shows the C1/F1 sign.
Temperature correction range is from -10 °C to +10 °C.
7 Press Manual/Pause button during heating, machine back to edit page. You can
edit Temp/Power/Timer, then press Manual/button again to confirm and machine
back to heating.
8 Long press TEMP for 5 seconds, switch degree centigrade to Fahrenheit. This
operation only can be proceeded when you switch on the machine before any
setting.