Klarstein MUNDSCHENK Mode D'emploi page 18

EN
18
Slide the component H through the center of the
component B and fasten it with component F.
Depending on the recipe and the quantity of output, it
makes sense to construct the sieves with either the short
(D) or long pipe (E).
4
Then, screw component
F onto the short or long
pipe. In this example, it
was screwed onto the long
pipe.
1
2
5
Now screw down the
upper perforated plate
including the pre-
assembled handles.
3
Next, attach the
handles (C) to the upper
perforated strainer (B).
6
The assembled screens are
now ready and can be
inserted into the pipe. The
combination should look
like this. The malt pipe
is now fully assembled
and can be placed in the
brewing kettle.