Bestway 58497 Manuel Du Propriétaire page 8

Control Valve are accessible for operation, servicing
and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter
to be vertically fixed on ground or a certain pedestal
made of wood or concrete before use to prevent the
sand filter from accidentally falling. Fully assembled
sand filter will exceed 18 kg. The mounting holes
should be 8 mm in diameter and spaced 86 mm apart.
Use two bolts and nuts with a maximum of 8 mm in
diameter to fasten the sand filter to the pedestal.
Load pool-grade filter sand/Flowclear
NOTE: Use only special pool-grade filter sand, free of all
limestone or clay: #20 Silica sand 0.45-0.85 mm, approximately
one 36 kg bag should suffice. If you do not use the recommended
size filter sand, filtering performance will be reduced and the
sand filter may damaged, thereby voiding warranty.
IMPORTANT: We suggest using #20 silica sand with your
pool sand filter. It is specially graded to trap particles in the
20 - 100 micron range.
Some small debris can pass throw the sand and back into the
pool. This is normal, especially if the debris is fine or silt.
To limit this, it is better to follow the maintenance instructions,
and backwash and rinse when necessary.
We also suggest contacting your pool dealer for the chemical
product specifically made to clean the sand. The correct
maintenance of the sand will optimize the cleaning efficiency
and avoid accumulation of oils or scale.
When you are vacuuming the bottom of the pool that has a
large amount of debris, we suggest to backwash the sand
when you finish cleaning half of the pool.
Remember to backwash and rinse the sand after vacuuming
the bottom of the pool each time.
NOTE: To avoid damaging the Skimmer when adding sand,
pour some water into the Bottom Tank to submerse the
Skimmer on the Collector Hub.
NOTE: Sand/Flowclear
NOTE: Use 28 g (0.06 lbs) Flowclear
1 kg (2.20 lbs) sand.
Polysphere not included.
™
Polysphere to replace
™
8
Polysphere.
™