Bestway 58497 Manuel Du Propriétaire page 11

RCD plug must be tested before each use.
WARNING: Do not use the sand filter if this test fails.
Please contact your local Bestway Aftersales Service.
WARNING: Insert the RCD plug into a residual current
device (RCD) having a rated residual operating not
exceeding 30 mA.
WARNING: Before inserting plug into a power outlet,
make sure the current rate of the power outlet is suitable
for the sand filter.
OPERATION
Timer
1.Plug into power source, adjust power switch to "ON" (-)
position. The sand filter will begin working immediately.
2.Adjust power switch to "OFF" (0) position. The sand filter
will stop working immediately.
3.After turning on, you can adjust work time, rest time and
cycle time by turning the knob to desired position. See the
table below for more details.
4.When the timer knob is moved into new position, the filter's
previous cycle automatically cancels so new cycle can begin.
5.Each time the filter is powered on or restarted, a new cycle
will begin based on timer knob position.
NOTE: If the knob is adjusted to the 24-hour position (24),
the sand filter will work continuously without any rest period.
11