hestan KDW Série Manuel D'entretien page 18

FEATURES AND CONTROLS
TROUBLESHOOTING
EN
Soak
E1
Soak
E2
Soak
E3
Soak
E4
Soak
E5
If an alarm situation occurs, the dishwasher interrupts the current program and
signals the problem.
• Alarms E1, E2, E3, E4, E8 and E9 immediately terminate the current cycle.
Alarms E5 and E6 interrupt the current cycle and, after the problem has been
eliminated, resume the cycle.
• Alarm E7 is displayed at the end of the cycle, which however, is completed
given that it does not jeopardize the operation of the dishwasher.
• For alarm E11, contact customer service.
To "reset" an alarm:
Open or close the door or switch off and back on again at this point the
•
dishwasher can be programmed again.
If the problem persists, contact an authorized technical servicer.
16
©2018 Hestan Commercial Corporation
(continued)
FAULT
Water pump-out malfunction
Super/
Crystal Delicate Daily Wash
The appliance does not pump out the water or does
Sanitize
so incorrectly. Make sure the drain hose is not kinked
or crushed and that the siphon and filters are not
clogged. If the problem persists, contact Technical
Service.
Turbine flow-regulator malfunction
Super/
The appliance is unable to precisely measure the
Crystal Delicate Daily Wash
Sanitize
quantity of incoming water. Interrupt the current cycle
and turn off the dishwasher. Turn it back on again,
program a new cycle and press start. If the problem
persists, contact Technical Service.
Alternate washing system malfunction
Super/
Crystal Delicate Daily Wash
Sanitize
Interrupt the current cycle and turn off the dishwasher.
Turn it back on again, program a new cycle and
press start. If the problem persists, contact Technical
Service.
Super/
Crystal Delicate Daily Wash
Water intake system malfunction
Sanitize
Contact Technical Service.
Super/
Water intake system malfunction
Crystal Delicate Daily Wash
Sanitize
Contact Technical Service.
Light off Light on
(continued)
DESCRIPTION
Light flashing