Lubrication; Important; Accessories - DeWalt DW937 Guide D'utilisation

382815-01/DW937 5/8/02 9:21 AM
FIG. 7
NOTE: In areas where blade visibility is limited, use the edge of the
saw shoe as a guide. Lines for any given cut should be extended
beyond edge of cut to be made.
Metal Cutting (Figure 10)
This unit has different metal cutting capacities depending upon type
of blade used and the metal to be cut. Use a finer blade for ferrous
metals and a coarse blade for non-ferrous materials. In thin gauge
sheet metals it is best to clamp wood to both sides of sheet. This will
insure a clean cut without excess vibration or tearing of metal.
Always remember not to force cutting blade as this reduces blade life
and causes costly blade breakage.
NOTE: It is generally recommended that when cutting metals you
should spread a thin film of oil or other coolant along the line ahead
of the saw cut for easier operation and longer blade life.

Lubrication

Your tool was properly lubricated before leaving the factory. In from
two to six months, depending upon use, take or send your tool to a
Service Center, or authorized service station, for a complete
Page 8
FIG. 8
ROCK TOOL UP TO FIG. 9
NORMAL CUTTING
POSITION AFTER
BLADE HAS CUT
THROUGH MATERIAL
STARTING POSITION FOR
POCKET CUTTING
cleaning, inspection and lubrication. Tools used constantly on
production jobs will need relubrication more often. Also, tools "out
of service" for long periods should be relubricated before being put
back to work.

Important

To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by qualified
service organizations. These service organizations service
D WALT tools always using D
E

Accessories

Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If
you need assistance in locating any accessory for your tool,
contact:
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286
8
FIG. 10
WALT replacement parts.
E