Initial Operation - YTORA TPW799 Mode D'emploi

A = MODE B = +

Initial Operation

After inserting the batteries, the main unit will connect with the outdoor sensor by RF
•
signal.
The RF signal symbol at the out area will flash.
•
This process takes about 3 minutes. Then the display shows the outdoor temperature
•
/humidity/wind speed/wind direction/rainfall. In case of failure of reception, press
"ALARM" for more than 3 seconds to start a new reception.
The automatic receiving of the DCF77 radio controlled clock (RCC) signal begins after the
•
outdoor RF reception has been completed.
While the RCC reception process is going on, the flashing symbol "radio tower" appears in
•
the time display area. In case the reception is good, the waves of the "radio tower" are
blinking. If the reception is not good, only the tower (without waves) will be blinking.
Once the RCC reception is successful, the symbol "radio tower" will be shown permanently,
•
no flashing, with the waves.
If, due to bad reception, or no automatic RCC time reception is possible, follow the steps
below to set the time manually.
Manual time set-up
In this Set-Up you make other settings too, such as 12/24 hour, time zone, languages,
display units etc.
Press and hold key "MODE" for 3 seconds.
•
The 12/24 hour flashing. Use "+" and "-" to select
•
Press "MODE" to confirm.
•
The display for the time zone is flashing. Use "+" and "-" to select the time zone
•
(-12 to +12).
Press "MODE" to confirm.
•
The DM/MD flashing, Use "+" and "-" to select
•
Press "MODE" to confirm.
•
The display for the year is flashing. Use "+" and "-" to select the year.
•
Press "MODE" to confirm.
•
The display for the month is flashing. Use"+" and "-" to select the month.
•
Press "MODE" to confirm.
•
The display for the date is flashing. Use "+" and "-" to select the date.
•
Press "MODE" to confirm.
•
The display for the hour is flashing. Use "+" and "-" to select the hour.
•
Press "MODE" to confirm.
•
The display for the minutes is flashing. Use "+" and "-" to select the minutes..
•
Press "MODE" to confirm.
•
The language selection for the display of the weekdays is flashing. Use "+" and "-" to
•
select the language.
Press "MODE" to confirm.
•
The C/F for temperature flashing. Use "+" and "-" to select.
•
Press "MODE" to confirm.
•
The hpa/inhg for air pressure flashing. Use "+" and "-" to select .
•
Press "MODE" to confirm.
•
The mm/inch for rainfall and kmh/mpg flashing. Use "+" and "-" to select .
•
Press "MODE " to confirm.
•
C = - D = ALARM E = ALERT F = SNOOZE/LIGHT