Mounting The Main Unit - YTORA TPW799 Mode D'emploi

NOTE:
First insert the batteries of main unit, then insert the batteries of the outdoor sensor within
•
3 minutes after the main unit is powered on, to assure that the sensor data is received well.
In case of the outdoor sensor data is not received, please press ALARM key for more than
•
3 seconds to synchronize the sensors signal again.
Every time the batteries are replaced in the main unit, it will loose all the weather data.
•
Every time the batteries are replaced in the sensor unit, it will synchronize with the main
•
unit only if you press the ALARM key for more than 3 seconds.

Mounting the main unit

•
The main unit can be placed onto any flat surface or wall mounted at the desired location
by
Hanging hole, it is important to check that the radio signal can be received before
mounting.
Mounting the outdoor sensor onto the stainless steel mast
•
For accurate results, the outdoor sensor mast should be securely mounted onto a
horizontal surface and in an open area away from trees and other coverings where
rainfall or wind speed may be reduced causing inaccurate reading.
1. Mounting the wind speed sensor to the first plastic bracket 1:
First check the wind-fan can rotate freely before fixing. The wind speed sensor should
now be mounted onto the bracket provided to allow the wind to travel around the
sensor unhindered from all directions. Please follow the below display: