YTORA TPW799 Mode D'emploi page 5

4. Mounting the thermo-hygro sensor to the third plastic bracket: once the wind
sensors and rain sensor are fixed onto the bracket, connect the cables to the
corresponding thermo-hygro sensor sockets with the plugs, so that data can be
transmitted to the main unit ,then put the house-like cover onto the thermo-hygro
sensor, please follow the below display:
NOTE: please don't put in or take off the plug very often, or put the plug outside in the air so
long time to avoid any damage of the plug, if so, there will be bad connection.
5. Mounting all the sensors onto the stainless steel mast and fix the whole parts
at outdoor open area :(note: please make sure all the cables are connected well
into the sockets: