Installing The Batteries - YTORA TPW799 Mode D'emploi

Main unit batteries: 3 x AA, LR6, 1.5V (not included)
•
Outdoor sensor:
Frequency: 433 MHz
•
Transmission range: 100 meters in open area.
•
NOTE: Actual distance may vary depending on the environment, it will be
shortened in real buildings due to electrical interference, concrete walls etc.
Batteries: 2 x AA, LR6 1.5V (not included)
•
Installation

Installing the Batteries

Open the main unit battery cover located at the back of the main unit and insert 3 pcs AA
•
batteries into the battery compartment and close the battery cover.
Pull away the shower proof casing of the thermo-hygro sensor to reveal the 2 sockets (the
•
sockets for the wind sensor and rain sensor )
1. Connect the wind speed sensor cable into the socket at the bottom of the of the wind
direction sensor
2. Connect the cable from wind direction and the cable from rain sensor to the
corresponding sockets of the thermo-hygro sensor by clicking them into place.
3. Make sure that rain and wind cables are connected to the correct sockets.