Adjusting The Sound - JVC KD-AR390 Manuel D'instructions

Range/selectable items
Sound
elements
BASS
Frequency 60 Hz
80 Hz
100 Hz
120 Hz
Level (LVL) –06 to
+06
Q Q0.5
Q1.0
Q1.5
Q2.0
BASS: Bass MID: Mid-range TRE: Treble
5
Repeat steps 3 and 4 to adjust other sound
characteristics.
The adjustment made will be stored automatically.

Adjusting the sound

You can adjust the sound characteristics to your
preference.
• The adjustment you make will be stored for the
currently selected sound mode (iEQ) including
"USER."
1
2
MID TRE
500 Hz 7.5 kHz
1.0 kHz 10.0 kHz
1.5 kHz 12.5 kHz
2.5 kHz 15.0 kHz
–06 to –06 to
+06 +06
Q0.75 Q0.75
Q1.0 Q1.25
Q1.25
Q1.5
FADER *
1
Adjust the front and rear speaker
output balance.
BALANCE * 2
Adjust the left and right speaker
output balance.
LOUD *
3 (loudness)
Boost low and high frequencies to
produce a well-balanced sound at a
low volume level.
SUB.W *
4 (subwoofer)
Adjust the subwoofer output level.
VOL ADJ (volume adjust)
Adjust the volume level of each source
(except FM), compared to the FM
volume level. The volume level will
automatically increase or decrease
when you change the source.
• Before making an adjustment,
select the source you want to adjust.
VOLUME
Adjust the volume.
*
1 If you are using a two-speaker system, set the fader
level to "00."
*
2 This adjustment will not affect the subwoofer output.
*
3 Loudness setting will be applied to all sound modes.
*
4 Displayed only when "L/O MODE" is set to "SUB.W"
(see page 23).
*
5 Depending on the amplifier gain control setting. (See
page 23 for details.)
R06 to F06
L06 to R06
LOUD ON or
LOUD OFF
00 to 08,
initial: 04
–05 to +05,
initial: 00
00 to 50 or
00 to 30 *
5
SETTINGS 21