Alecto AK-30 Guide De L'utilisateur page 29

12/24 hours: Press the "-" button to switch between 12 hours
and 24 hours display format.
Remarks: When you don't press any button for 15 seconds
during the settings, the screen automatically returns to the
normal display. Briefly press the "MODE" button to display the
day.
Alarm clock and snooze settings:
This clock also provides wake-up functions. You may set 1
wake-up time. The alarm clock is activated when the alarm
clock icon appears in the display, by sliding the sliders at the
sides upwards to the "ALARM ON" position. While the snooze
function is active, the snooze icon Z keeps flashing. Every
Z
5 minutes an alarm signal will sound. While the alarm is active,
the alarm clock icon keeps flashing.
Wake-up time setup:
Press and hold the "ALARM SET" button for 3 seconds to open
the alarm clock settings. The temperature display (if the slider
at the bottom right is set to "OFF") is replaced by "ALARM
TIME" and the hours of the alarm time start flashing.
Use the "+" and "-" buttons to set the desired wake-up time.
Now press the "MODE" button to confirm your setting. The
minutes of the alarm time start flashing. Use the "+" and "-"
buttons to set the minutes of the wake-up time and then press
the "MODE" button to confirm your setting.
The wake-up time(s) is/are now set.
To activate the wake-up time, slide the "ALARM ON" switch
on the right upwards. The alarm clock icon appears in the
display and the temperature display is replaced by the wake-up
time.
-29-