Led Display; Maintenance And Storage - AL-KO MAMMUT Mode D'emploi

Assembly
Observe images 1 to 24 when assembling the
power pack!
Risk of electric shock
Disconnect the device from the power supply
„
before performing any kind of work!
Danger!
Due to electric shock
„
Risk of fire and explosion
„
Risk of flying parts
„
The device may only be assembled in the caravan
and connected to the power supply by a specialist
individual or a specialist workshop!
Specialist electrical knowledge and suitable tools
are required for safe installation and operation!
Risk of electric shock
Do not touch the battery contacts Do not re-
„
move the protective caps
Connect the device to the 230V supply net-
„
work in accordance with the national installation
specifications
Do not cover the vent holes in the box; keep a dis-
„
tance of at least 15 cm from the vent holes
In the case of all feed-throughs, ensure there are no
„
lines in the working area
Only assemble in dry spaces with sufficient ventila-
„
tion
Because caravan floors differ greatly, we deliber-
ately supplied no screws. It is the responsibility of
the user to choose a suitable assembly location
and suitable screws. We recommend min. two steel
screws with a core diameter of min. 4mm per re-
taining bracket.
Operation
Check the device and lines for damages before every
„
use; do not use the device if damaged
Only manoeuvre caravans over short distances
„
Check the lashing straps are secure before driving
„
693 816_b

LED Display

Operating
status
while charg-
<80%
ing
Yellow Yellow Green
LED colour
Base charge X
Recharging
End of charging
/ trickle charg-
ing
Pause mode X
If the battery was totally discharged, a malfunc-
tion message may light up on the charger during
the charging process (red LED). To continue the
charging process, remove the device and re-insert
it again. The battery then continues to charge until
it is fully charged.

Maintenance and Storage

Risk of electric shock
Disconnect the device from the power supply
„
before performing any kind of work!
Only have repairs done by specialists
„
Only replace defective fuses if the cause of the fault
„
is known and has been rectified
Only use original spare parts
„
Never bridge or repair fuses
„
Cleaning
Risk of short circuit
Clean the device with a dry, soft cloth. Do not
„
use any liquids or corrosive cleaners
GB
LED display
>80%
100%
U< 11.4 V, flashing
X
X
X
Alternately flashing
13