About The Controls On The Air Conditioner; Air Direction - GE AJCM 08 ACD Série Manuel D'utilisation Et Instructions D'installation

About the controls on the air conditioner

Vent Control
The vent control is located behind the front grille on the
right side of the air discharge area. When CLOSED, only
the air inside the room will be circulated and conditioned.
When OPEN, the vent allows outdoor fresh air exchange.
To open or close the vent:
1. Remove the front grille.
2. Remove the vent card screw.
3. Remove vent card, turn it over and replace it by
locating rear hole in card over locating pin inside air
discharge and reattaching screw at front.

Air Direction

Auxiliary Controls – Dip Switches (location varies by model)
The auxiliary dip switch controls are located
behind the room cabinet—as shown in this figure.
The owner is responsible for checking switches
and ensuring they are in the desired position.
Fan Cycle/Continuous - Cool
When this switch is enabled (UP), it allows the indoor
fan to cycle on/off with the compressor. When this
switch is disabled (DOWN), it allows the indoor fan to run
continuously. The default setting is down (continuous).
Fan Cycle/Continuous - Heat (on some models)
When this switch is enabled (UP), it allows the indoor fan
to run continuously with the heater operation. When this
switch is disabled (DOWN), it allows the indoor fan to
cycle on/off. The default setting is down (cyclic).
Class 2 - Remote Thermostat (on some models)
When this switch is enabled (UP), it allows the unit
to operate with a Class 2 Remote Control Wall
Thermostat. The unit controls are disabled.
The default setting is down (disabled).
8
The unit leaves the factory set at the CLOSE position.
Horizontal louvers
on the front grille let
you control the air
direction up and down.
Locating hole
Screw hole
OPEN position
(Mesh end toward back)
Fan Cycle/Continuous - Cool
Fan Cycle/Continuous - Heat (on some models)
Class 2 (on some models)
No function (reserved
Fan Cycle/Continuous - Cool
Fan Cycle/Continuous - Heat (on some models)
Class 2 (on some models)
Locating hole
Screw hole
CLOSE position
(Mesh end toward front)
Remove the front grille
to adjust the vertical
louvers side-to-side
to direct the air left
or right.
for future use)