Kärcher BP 1 Barrel Mode D'emploi page 9

Contents
General information
Operation
Maintenance
Transport
Storage
Special accessories
Troubleshooting
Specifications
General information
Please read these original operating in-
structions and the enclosed safety in-
structions prior to the initial use of your device. Proceed
accordingly. Keep both booklets for future reference or
subsequent owners.
Please keep in mind that the label "100% tested" may
not be removed from the pump. If the label is removed,
there will be no more warranty for the tightness of the
pump.
Proper use
This appliance has been designed for use in private
households and is not intended for commercial use.
The manufacturer is not responsible for any damages
that may occur on account of improper use or wrong op-
erations.
The appliance is mainly intended to remove rain water
from collection containers.
Approved fluids
Water with impurities up to a maximum grain size

of 1mm
 Water from swimming pool (provided the dosing of
additives is proper)
 Washing lye
Environmental protection
The packaging material can be recycled.
Please do not place the packaging into the or-
dinary refuse for disposal, but arrange for the
proper recycling.
Old appliances contain valuable materials that
can be recycled. Please arrange for the proper
recycling of old appliances. Please dispose
your old appliances using appropriate collec-
tion systems.
Notes about the ingredients (REACH)
You will find current information about the ingredients at:
www.kaercher.com/REACH
Warranty
The warranty terms published by the relevant sales
company are applicable in each country. We will repair
potential failures of your appliance within the warranty
period free of charge, provided that such failure is
caused by faulty material or defects in manufacturing. In
the event of a warranty claim please contact your dealer
or the nearest authorized Customer Service centre.
Please submit the proof of purchase.
EN 1
EN 1
1
EN 2
2
EN 2
3
EN 2
4
EN 3
5
EN 3 6
7
EN 4
8
9
10 Level sensor
11 Level switch attachment
12 Carrying handle
13 Hose connection G
 Screw the hose connection on to the pump
 Connect the hose connection to the hose coupling
Risk of mortal danger on account of electric shock!
Do not touch the feed fluid and the rope fastened to the
carrying handle during operation.
NOTICE
The liquid level must at least be 3 cm for the pump to
suck in liquids independently.
If the prerequisites for the pump operation are met (wa-
ter level, position / level switch), the pump will start im-
mediately after the mains plug has been plugged in.
Comfort operation
In order to run the pump independently of the water lev-
el, the level switch must be mounted inside the housing.
Illustration
 Screw the housing bowl and the O-ring onto the
 Place the level switch into the housing bowl.
 Press the housing cover down onto the housing
Illustration
 Slide the drum edge holder onto the container edge
Illustration
 Place the pump on a stabil surface in the liquid to
Illustration
 Close locking tap (arrow horizontal).
 Insert the mains plug into the socket.
 Rotate the housing with the level switch in the ar-
 The pump will turn on.
 Open the locking tap to remove water (arrow verti-
– 1
EN
Operation
Description of the Appliance
Power cord with plug
Drum edge holder
Locking valve
O ring
Housing bowl for level switch
Housing cover for level switch
Hose coupling
Pressure hose
Hose clamp
/ (24.4 mm)
3
4
for hose coupling
Before Startup
of the drum edge holder.
Operation
DANGER
drum edge holder.
bowl until it locks.
until it is properly seated.
be transported. Immerse it using a rope tied to the
handle or hang it into the container by the hose.
The suction area should not be blocked fully or par-
tially through the impurities.
row direction "ON".
cal).
9