Safety Instructions; Safety Rules - Annovi Reverberi MIRAGE 121 Mode D'emploi

1

SAFETY INSTRUCTIONS

1.1 the appliance you have purchased is a technologically advanced
product designed by one of the leading european manufacturers
of high pressure pumps. to obtain the best performance from your
unit, read this booklet carefully and follow the instructions each
time you use the it. We congratulate you on your choice and wish
you successful operation.
2

SAFETY RULES

2.1 SAFETY "MUST NOTS"
2.1.1
any products which are not compatible with the correct operation
of the appliance. e
xplosion or poisoning hazard
DO NOt direct the water jet towards people or
2.1.2
animals. i
DO NOt direct the water jet towards the unit
2.1.3
itself, electrical parts or towards other electrical
equipment. e
lectric shock hazard
DO NOt use the appliance outdoors in case of rain. s
2.1.4
circuit hazard
DO NOt allow children or incompetent persons to use the
2.1.5
appliance. i
njury hazard
DO NOt touch the plug and/or socket with wet
2.1.6
hands. e
DO NOt use the appliance if the electrical cable is
2.1.7
damaged. e
DO NOt use the appliance if the high pressure
2.1.8
hose is damaged. e
DO NOt jam the trigger in the operating position. a
2.1.9
hazard
check that the data plates are affixed to the appliance, if
2.1.10
not, inform your dealer. units without plates must NOt
be used as they are unidentifiable and potentially dangerous.
a
ccident hazard
2.1.11 DO NOt tamper with or alter the calibration of the
safety valve. e
DO NOt alter the original diameter of the spray head
2.1.12
nozzle. h
azardous alteration of operating performance
DO NOt leave the appliance unattended. a
2.1.13
DO NOt move the appliance by pulling on the
2.1.14
ELECTRICAL CABLE. s
Make sure that cars do not drive over the high pressure hose.
2.1.15
2.2 SAFETY "MUSTS"
all electrical conductors Must Be PrOtecteD against the
2.2.1
water jet. s
hort circuit hazard
the appliance Must ONLY Be cONNecteD to an
2.2.2
adequate power supply in compliance with all
applicable regulations. e
• Use of a safety residual current circuit-breaker (R.C.C.B.) will
provide additional protection for the operator (30 ma).
2.2.3
at speed; therefore protective clothing and safety goggles Must
Be WOrN. i
njury hazard
DO NOt use the appliance with
inflammable or toxic liquids, or
njury hazard
lectric shock hazard
lectric shock and short circuit hazard
xplosion hazard
xplosion hazard
ccident hazard
hort circuit hazard
lectric shock hazard
the high pressure may cause
materials to bounce off surfaces
Before doing work on the appliance, reMOVe the plug.
2.2.4
a
ccidental start
2.2.5 Before pressing the trigger, GriP the gun firmly to
counteract the recoil. i
cOMPLY With the requirements of the local water supply
2.2.6
company. according to DiN 1988, the appliance may only
be connected to the mains drinking water supply if a backflow
preventer valve with drain facility is installed in the supply hose.
c
ontamination hazard
Maintenance and/or repair of electrical components Must
2.2.7
be carried out by qualified staff. a
DischarGe residual pressure before disconnecting the
2.2.8
unit hose. i
Before using the appliance, checK every time that the
2.2.9
screws are fully tightened and that there are no broken or
worn parts. a
2.2.10
of the high pressure hose/electrical cable. e
shock hazard
hort
2.2.11
ccident
English
-
up hazard
njury hazard
ccident hazard
njury hazard
ccident hazard
ONLY use detergents which will
not corrode the coating materials
eNsure that all people or animals keep a minimum
distance of 16 yd. (15m) away. i
11
xplosion and electric
njury hazard