Cleaning And Care - Barista CM1025AE-GS Mode D'emploi

EN
11. Press the buttonStart / Stopp (Start / Stop) (19) to start the brewing process. The
operating lamp (18) lights up and
over the coffee powder to brew it.
If the brewing process is to be aborted prematurely, press the Start / Stopp
(Start / Stop) button. The operating lamp goes out and the device is switched off. (
goes out on the display.
At the end of the brewing process, 3 beeps sound and the device switches on the keep-
hot function automatically.
for up to 35 minutes and the operating lamp continues to be lit. After 35 minutes 3 beeps
sound again and the device switches off automatically. The operating lamp goes off.
Making Coffee with a Preset Time
To make coffee with a preset time, the clock needs to be set (see the "Handling
and Operation" chapter | "Time").
1. Prepare the coffee machine, add coffee beans or coffee powder, pour in water, insert
a fi lter (see the "Handling and Operation" chapter).
The desired coffee strength, number of cups etc. can be set before or after acti-
vating the preset time.
2. Keep the button Timer (22) pressed down for approx. 3 seconds until the displayed
time fl ashes.
3. Use the buttons Std (Hr) (16) and Min (17) to set the start time you want (see the
"Handling and Operation" chapter | "Time").
4. To activate the preset time, press the button Timer again. The control lamp next to
the button Timer lights up constantly.
time is activated.
To make coffee with coffee powder, the button Mahlwerk Aus (grinding mecha-
nism off) (21) must be switched on and the control lamp next to the button must
light up.
Once the preset time is reached, the device switches on automatically. The display (14)
shows the programmed settings and
Deactivating the Preset Time
To deactivate the preset time setting, press the button Timer (22). The control lamp next
to the button goes out, the
However, the preset time is retained and can be reactivated at any time until a new pre-
set time is programmed in or the device has been disconnected from the power supply
for more than a minute.

Cleaning and Care

NOTE
■ Before commencing the cleaning, note the safety instructions in the "Safety
Instructions" chapter!
■ Do not use any caustic or abrasive cleaning agents for cleaning. These can damage
the surface.
28
appears on the display.
goes out on the display. The device remains in operation
appears on the display (14). The preset
.
symbol goes out and the programming is deactivated.
Hot water is poured