EN
Before Initial Use
NOTE
■
Always set up the device with a clear space at the sides (at least 20 cm) and clear
space above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is re-
sistant to splashing.
■
Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
■
The surfaces of furniture may possibly contain elements which can attack and soften
the adjustable feet of the device. If necessary, place a suitable pad below the adjust-
able feet.
■
There may still be some production residues on the device. To avoid harmful effects
to your health, clean the device before you fi rst use it (see the "Cleaning and Care"
chapter).
1. Wipe down the device with a clean, damp cloth. Rinse the glass jug (9), the fi lter
insert (12) and the permanent fi lter (13) as well as the measuring spoon with a little
mild detergent and clear water.
2. Set up the device in a suitable location, following the safety instructions and the notes
provided at the beginning of this chapter.
3. Plug the mains plug into a properly installed, easily accessible plug socket which
corresponds to the technical data of the device. The display (14) lights up and the
time display fl ashes.
4. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run with
coffee beans to remove any possible production residues in the water system and in
the grinder shaft. To do this, follow the instructions in the "Handling and Operation"
and "Use" chapters.
When the device is fi rst used, production-related additives (e.g. grease) may
cause a small amount of smoke and / or an odour to be produced. This is normal
and not a device defect.
5. Perform this process twice. Caution! Do not drink this coffee!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).
Handling and Operation
NOTE
■
Do not pour milk or other liquids into the water tank. Only ever use water to make
coffee!
■
Never overfi ll the permanent fi lter.
Display Lighting
The display lighting goes out 60 seconds after the last button has been pressed, unless
the device is in operation. The display (14) lights up as soon as a button is pressed.
24