FTX Kanyon Mode D'emploi page 6

Etronix Pulse EX2 Sport
2.4GHZ RADIO SET-uP
2 Channel 2.4GHz Steer Wheel Transmitter
1) INTRODUCTION.
Thank you for choosing this Etronix
2.4GHz radio system, it has been
designed for land use but could also
suit any 2 channel boat. If you are using
this type of product for the very first
time, please make sure you read all the
information provided before installing in
your vehicle. Please take special care
of any warning notices to ensure safe
operation.
2) SERVICE.
If you experience any difficulties please
refer back to the manual, and if
problems persist contact your retailer
or distributor for further assistance.
3) SAFETY.
If you do not read, fully understand,
then follow the advice and instructions
in this manual properly, you risk
damaging your radio or your model
irreparably, even injury, or causing harm
to another person or their property.
4) USER GUIDES.
Do Not drive at night, in bad weather,
thunder and lightning, during rain, or on wet roads.
Do Not drive in the street between parked cars, near people or children,
or dog walkers.
Always check the proper operation of your model. If it does not respond
properly or reacts unpredictably please check the installation and
condition of your equipment.
Ensure the throttle trigger is at the neutral position before powering up,
to avoid your model running away before you get proper control.
Never turn off the transmitter before the receiver, although fitted with a
failsafe device, it is good practice to keep the model under control at all
times.
Remember :- Transmitter on first. Receiver off first!
5) BATTERY CARE.
If your transmitter or receiver is being power by rechargeable Nickel
Cadmium or Nickel Hydride batteries, be sure to always check they are
fully charged and in good condition before use. Loss of control could
soon result if part charged, discharged or damaged batteries are
installed. When charging NiCd or NiMH batteries always use a dedicated
charger, never try to recharge dry cells. If at any time during use or
charging your transmitter or receiver batteries show signs of severely
over heating, swelling or leaking, disconnect immediately, dispose of
properly and replace!
6) TRANSMITTER CHARGING.
Connect a dedicated transmitter charger to the power
supply.
Connect the charger to the charging socket on the
rear of the handset.
When charging is complete, disconnect.
If using dry (alkaline) cells do not attempt to connect a
charger to the transmitter!
Install eight 1.5V (AA size) rechargeable
batteries in the transmitter base and re-fit the
7) TRANSMITTER SPECIFICATION.
Channels :
Frequency:
RF Power :
Modulation:
Code Type:
Sensitivity:
Power:
Low Voltage Warning:
Charger Port:
DSC Port:
Antenna Length:
Weight:
Size:
Colour:
Certification:
6
bottom cover.
2
2.4GHz
<20 dbm
GFSK
Digital
1024
12V DC (8 x 1.5V AA)
<9V DC
5mm Centre Positive
(Charger Not Included)
3.5mm
(for Optional USB Game Interface –
NOT USED/SUPPORTED)
120mm
328g
159 x 99 x 315mm
Black
CE, FCC.