Controls - Norcold N10DCX-10 Manuel D'installation

Controls:

-
Touch and release the ON/OFF [1] button to turn the refrigerator on.(ART02735)
- If the indicator light, below the button, glows solid blue, it means the refrigerator is operating correctly.
The freezer compartment and cabinet work
NOTICE
independent of each other and both must be
adjusted to their desired
temperature setting.
- Touch the FREEZER COMPARTMENT [5] button to set the compartment temperature setting.
-Using the + [4] or – [2] buttons adjust the temperature setting.
- The mode [3] will display the temperature setting
- 0 is off
- 1 is the warmest setting
- 5 is the coldest setting
- Touch the CABINET COMPARTMENT [6] button to set the
compartment temperature setting.
- Using the + [4] or – [2] buttons adjust the temperature setting.
- The mode [3] will display the temperature setting
- 0 is off
- 1 is the warmest setting
- 5 is the coldest setting
- Press any button to return the control to activate mode, the mode [3] will illuminate. The display will return to standby mode after 5
seconds.
-Touch the NIGHT MODE [7] button to set the refrigerator to night mode.
- Night mode will turn off automatically after 8 hours or if you push the night mode button again to turn the blue indicator light off.
- These 8 hours can be changed by pressing the night mode button for 3 seconds. After the 3 seconds, the default 8 hour will be shown
in the display . To change this setting, press the "+" or "-", then press night mode button to make the setting go into effect.
- The new setting is archived in the memory until it is changed.
Shut down:
- To shut down the refrigerator, touch and hold the ON/OFF button [1] for 5 seconds and release
- Once the refrigerator is turned OFF there is a 5 minute wait cycle before the refrigerator can be turned ON. The refrigerator will not
turn on again until the 5 minute wait is up.
Do not operate the refrigerator when the ambient temperature is higher than 140° F operation above the
!
CAUTION
recommended ambient temperature can cause permanent damage to the compressor. Operation when the
ambient temperature is higher than 110°F can result in poor cooling performance.
1 4
2 3
6
5 7
ART 02735
Installation Manual 9