Samsung BD-E8300 Manuel D'utilisation page 34

Settings
< Getting the Network Settings Values >
You can view your Network Settings values on
most Windows computers. To view the Network
Settings values, follow these steps:
• Windows XP
1.
Right click the Network icon on the bottom
right of the Windows desktop.
2.
In the pop-up menu, click Status.
3.
On the dialog that appears, click the Support
tab.
4.
On the Support tab, click the Details button.
The Network settings are displayed.
• Windows 7
1.
Click the Network icon on the bottom right of
the Windows desktop.
2.
In the pop-up menu, click Network and
Sharing Centre.
3.
On the dialog that appears, click the Local
Area Connection or Wireless Network
Connection depending on your network
connection.
4.
On the Support tab, click the Details button.
The Network settings are displayed.
| NOTE |
\ Depending on your Windows version, the information may
differ.
Wireless Network
You can setup a wireless network connection in
three ways:
- Wireless Automatic
- Wireless Manual
- WPS(PBC)
When you configure the wireless network
connection, any wireless network devices
currently connected through the product will be
disconnected.
| NOTE |
\ Wireless network connection cannot be configured if
Wired internet connection is already established.
34
|
English
Wireless (General) - Automatic
Ğ
After followng Steps 1 to 3 in "Configuring Your
Network Connection" on page 33.
1. Select Start in the Network Settings screen,
and then press the v button.
The product searches for and then displays a
list of the available networks.
Network Settings
Select your wireless router from the list.
iptime23
ELT
JSY
KT_WLAN_C361
Mirhenge_edu
SO070VOIP
2.
Select the desired network, and then press
the v button.
3. Select Next, and then press the v button
again.
4.
On the Security screen, enter your network's
Security Code or Pass Phrase.
Enter numbers directly using the number
buttons on your remote control. Enter letters
by selecting a letter with an arrow button, and
then pressing v button.
5. When done, select Next at the right of the
screen. The product verifies the network
connection and then connects to the
network.
| NOTE |
\ If the desired router is not visible or if too many routers
are listed, perform the following instructions. You can
connect to a desired router.
1) Perform up to step 2 above.
2) Select Add Network.
3) Provide a name (SSID) for the wireless router.
4) Select security type.
\ You should be able to find the Security Code or Pass
Phrase on one of the set up screens you used to set up
your router or modem.
Refresh
WPS(PBC)
Previous
Next
Cancel