Campbell Hausfeld PW320200 Instructions D'utilisation page 5

This product may not be equipped with a spark-arresting muffler. If the product is not equipped
and will be used around flam ma ble ma teri als or on land covered with materials such as
agricultural crops, forest, brush, grass or other similar items, then an ap proved spark arrester must be installed and is
legally required in the state of California. It is a violation of California statutes section 130050 and/or sec tions 4442 and
4443 of the California Public Re sourc es Code, unless the engine is equipped with a spark arrester, as defined in section
4442, and maintained in ef fec tive work ing order. Spark arresters are also required on some U.S. For est Service land and
may also be legally required under other statutes and or di nanc es.
RISK OF FLUID INJECTION AND LACERATION:
• Your pressure washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh
which could result in amputation or other serious injury. Leaks caused by loose fittings or worn or damaged hoses can
result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician immediately!
- Inspect the high pressure hose regularly. Replace the hose immediately if it is damaged, worn, has melted from
contacting the engine, or shows any signs of cracks, bubbles, pinholes, or other leakage. Never grasp a high
pressure hose that is leaking or damaged.
- Never touch, grasp or attempt to cover a pinhole or similar water leak on the high pressure hose. The stream of
water IS under high pressure and WILL penetrate skin.
- Never place hands in front of noz zle.
- Direct spray away from self and others.
- Make sure hose and fit tings are tightened and in good condition. Never hold onto the hose or fittings during
op er a tion.
- Do not allow hose to contact muf fler.
- Never attach or remove wand or hose fittings while sys tem is pres sur ized.
- When using replacement lances or guns with this pressure washer, DO NOT use a lance and/or lance/gun
combination that is shorter in length than what was provided with this pressure washer as measured from the
nozzle end of the lance to the gun trigger.
• Injuries can result if system pressure is not reduced before attempting maintenance or disassembly. To relieve
sys tem pres sure, shut off engine, turn off water sup ply and pull gun trigger until water stops flowing. Use only
accessories rated equal to or higher than the rating of the pressure washer.
RISK OF INJURY FROM SPRAY:
• High-velocity fluid spray can cause objects to break, projecting particles at high speed. Always wear ANSI-approved
Z87.1 safety glasses. Wear protective clothing to protect against accidental spraying. Never point wand at or spray
people or animals.
• Light or unsecured objects can become hazardous projectiles. Always secure trigger lock when wand is not in
service to prevent accidental operation. Never permanently secure trigger in pull-back (open) position.
3