Precautions For Installation - Panasonic WV-Q119 Manuel D'utilisation

Precautions for installation

i-PRO Co., Ltd. assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this documen-
tation.
The installation should comply with local
electrical code.
This product is designed to be used
indoors.
This product is not operable outdoors.
Do not expose this product to direct sunlight
for hours and do not install the product near a
heater or an air conditioner.
Otherwise, it may cause deformation, discolor-
ation and malfunction. Keep this product away
from water and moisture.
Do not use this bracket except with suit-
able cameras.
Installation area for this product
• Make sure that the installation area is strong
enough to hold the total weight of the cam-
era assembly before installation.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
Do not place this product in the following
places:
• Locations where it may get wet from rain or
water splash (including under the eaves,
etc.)
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to moisture or oil smoke
such as a kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic field
is generated
4
• Locations where corrosive gas is produced,
locations where it may be damaged by
briny air such as seashores
• Locations where the temperature is not
within the specified range (–10 °C to +55 °C
{14 °F to 131 °F})
• Locations subject to vibrations, such as on
vehicles, marine vessels, or above product
lines (This product is not designed for on-
vehicle use.)
• Locations subject to condensation as the
result of severe changes in temperature
Mounting method for this product
This product is designed to be used as a pen-
dant mount camera. If the product is mounted
on a desktop or at a slant, it may not work cor-
rectly and its lifetime may be shortened.
Procure fixing screws separately.
Screws for mounting this bracket are not sup-
plied.
Prepare them according to the material and
strength of the area where the product is to be
installed.
• Required screws: M4 (4 pcs.)
• Minimum pull-out strength: 196 N {44 lbf}
Screw tightening
• The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
• Do not use an impact driver. Use of an
impact driver may damage the screws or
cause tightening excessively.