7
What to do in case of a problem
The hob or the cooking zone doesn't start-up:
• The hob is badly connected on the electrical
network.
• The protection fuse cut-off.
• The looking function is activated.
• The sensitive keys are covered of grease or
water.
• An object is put on a key.
The control panel displays [ U ]:
• There is no pan on the cooking zone.
• The pan is not compatible with induction.
• The bottom diameter of the pan is too small.
The control panel displays [ E ]:
• The electronic system is defective.
• Disconnect and replug the hob.
• Call after sales
One or all cooking zone cut-off:
• The safety system functioned.
• You forgot to cut-off the cooking zone for a long
time.
• One or more sensitive keys are covered.
• The pan is empty and its bottom overheated.
• The hob also has an automatic reduction of
Booster level and breaking Automatic overheat-
ing
Continuous ventilation after cutting off the
hob:
• This is not a failure, the fan continuous to pro-
tect the electronic device.
• The fan cooling stops automatically.
The automatic cooking system doesn't start-
up:
• The cooking zone is still hot [ H ].
• The highest Booster level is set [ 9 ].
The control panel displays [
• Refer to the chapter "Keep warm".
The control panel displays [ II ]:
• Refer to the chapter "Stop&Go"
20 / EN
The control panel displays [
• An object or liquid covers the control keys. The
symbol disappear as soon as the key is released
or cleaned.
The control panel displays [ E2 ] :
• The hob is overheated, let it cool and then turn
it on again.
The control panel displays [ E8 ] :
• The air inlet of the ventilator is obstructed, re-
lease it.
The control panel displays [ U400 ] :
• The hob is not connected to the network. Check
the connection and reconnect the hob.
The control panel displays [ Er47 ] :
• The hob is not connected to the network. Check
the connection and reconnect the hob.
If one of the symbols above persists, call the after
sales service.
]:
] or [ Er03 ] :
Induction Hob / User Manual