Connect To Power Source - Beko HPI 214 B Manuel D'utilisation

3 Operation
3.1 Placing the pot on the
ceramic plate
• Make sure the air vents are not blocked and keep
utensils away from the immediate surrounds of
the ceramic plate.
• Make sure the cookware which has food or liquid
is placed in the center of ceramic plate.

3.2 Connect to power source

• Insert the plug into the wall socket.
• After the power supply is connected, the buzzer
sounds. The display shows "L", indicating that
the induction hob is in standby mode.
3.3 Turn on
• After pressing the "ON/STANDBY" button, the
induction hob is ready for heating. Press the
function button to start heating.
• After pressing the "ON/STANDBY" button, if no
function button are pressed, the induction hob
will switch off automatically.
• In working mode, if there is no proper pot on the
ceramic plate, the induction hob will not heat up
and the alarm will sound to indicate that a pot is
required. About One minute later, it will switch
off automatically.
3.4 Function
3.4.1 Power function
• In order to select the power intensity you can:
– Either press the "+/-" buttons.
– Or select to the slider, by swiping your finger
from left to right on the button.
• To guide you, lights appear above each temper-
ature level.
12 / EN
3.4.2 Keep warm mode
When the appliance is in operation, press the
"Keep warm" button if you want to keep your food
or liquid warm. The appliance will automatically
set to the lowest power and will stop after 120
minutes. To set again the power, Press directly on
the "+/-" button.
3.4.3 Simmer mode
To use this mode, press on the "Simmer" button. A
lamp lights up. The induction hob enters the sim-
mer state, the default power level shall be level 2.
Under this mode, the power cannot be adjusted.
Press "+/-" button or slider to enter normal power
mode.
3.4.4 Boil mode
Boil mode is for boiling water. To use this mode,
press on the "Boil" button. A lamp lights up. The
default power level shall be level 8. In this mode,
the default working time is 15 minutes.
C
It is recommended to put water that
occupies 30%- 80% of the pot ca-
pacity when boiling water.
3.4.5 Fry mode
To use this mode, press on the"Fry" button. A lamp
lights up. The default power level shall be level 5.
After several minutes, it will turn to 3 level power.
Press "+/-" button or slider to enter normal power
mode.
3.4.6 Deep fry mode
To use this mode, press on the"Deep fry" button.
A lamp lights up. The default power level shall be
level 8. After several minutes, it will turn to 7 level
power. Press "+/-" button or slider to enter normal
power mode.
Induction Hob / User Manual