Milwaukee 4555-22 Manuel D'utilisateur page 16

Make sure the nozzle and hose connections are
secure before starting the machine. A non-secured
accessory could become a projectile if not properly
installed which could result in serious injury.
SELECTING THE CORRECT QUICK-CONNECT
NOZZLE FOR THE JOB
See Figure 17.
Before starting any cleaning job, determine the best
nozzle for the job. Each of the five nozzles has a different
spray pattern. The nozzle colors and spray patterns are:
black (low pressure), white (medium pressure) 40˚, green
(medium pressure) 25˚, yellow (high pressure) 15˚, and
red (high pressure) 0˚.
NOTE: For a gentle rinse or cleaning large areas,
select the white 40˚ or green 25˚ nozzle. Scouring the
surface requires a more direct spray of water. Select the
yellow 15˚ or red 0˚ nozzle for tough jobs. Apply detergent
using the black nozzle with the thumb dial in the MAX
position and the detergent metering valve in any posi-
tion other than off. Use only specifically recommended
nozzles.
NEVER change nozzles without locking the
lock off on the spray wand and NEVER point
the wand at your face or at others. The quick-
connect feature contains small springs that
could eject the nozzle with some force. Failure
to heed this may cause personal injury.
Using the quick-connect collar, changing nozzles is quick
and easy.
1. Place ON / OFF Switch in the OFF ( O ) position.
2. Shut off the water supply at the water main then pull
the spray wand trigger to release water pressure.
To connect a nozzle to the spray wand:
1. Engage the lock on the wand by pushing up on the
lock off until it clicks into the slot.
2. Insert the desired nozzle. Push until a "click" is heard.
Tug on the nozzle to be certain it is secured properly
before releasing the lock off on the wand.
3. Release the lock off on the wand by pushing it down
into its original position.
page 16
WARNING
WARNING
OPERATION
To disconnect a nozzle from the spray wand once the
cleaning job is complete:
1. Place ON / OFF Switch in the OFF ( O ) position.
2. Shut off the water supply at the water main then pull
the spray wand trigger to release water pressure.
3. Engage the lock off on the wand by pushing up on the
lock off until it clicks into the slot.
4. Pull back and remove the nozzle. Place nozzle in the
nozzle storage area on top of the machine.
Fig. 17
SPRAY WAND
EXTENSION
Never lift or carry this machine using the moving
handle. Do not move this machine by pulling on the
hoses.
MOVING THE PRESSURE WASHER
See Figure 18.
1. Place ON / OFF Switch in the OFF ( O ) position.
2. Standing at the back of the machine, grasp the handle
firmly with both hands.
3. Tilt the machine toward you until it balances on the
wheels then roll the machine to the desired position.
QUICK-CONNECT
COLLAR
"CLICK"
WARNING
NOZZLE