Homelite UT80993 Manuel D'utilisation page 12

PACKING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-connect Nozzles (4)
4-Cycle Engine Oil (SAE 30 or SAE 10W30)
Handle
Injection Hose
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
INSTALLING THE HANDLE
See Figure 2.
 Push and hold the button on the handle as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock
button snaps through the locking slot to secure the
handle in place.
ASSEMBLING THE TRIGGER HANDLE
See Figure 3.
 Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
 Turn the connector clockwise until it stops. This secures
the spray wand in place.
ASSEMBLY
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 4.
 Screw the collar on the high pressure hose into the
trigger handle inlet coupler by turning the hose collar
clockwise.
 Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO
THE PUMP
See Figure 5.
After the high pressure hose has been uncoiled and attached
to the spray wand:
 Align the collar on the threaded nipple on the pump.
 Insert the the end of the high pressure hose collar into
the threaded nipple.
 Turn the collar clockwise to tighten the hose securely to
the pump.
 Pull on the hose to be certain it is properly secured.
CAUTION:
Do not run the pressure washer pump without water sup-
ply connected and turned on, as this may damage the
high pressure seals and decrease pump life. Completely
unwind the hose from its reel or coil and make sure the
hose is not being restricted by tires, rocks, or any other
objects that may lessen or prevent water flow to the
pressure washer.
CONNECTING THE GARDEN HOSE TO THE
PRESSURE WASHER
See Figure 6.
CAUTION:
Always observe all local regulations when connnecting
hoses to the water main. Some areas have restrictions
against connecting directly to public drinking water sup-
ply to prevent the feedback of chemicals into the drinking
water supply. Direct connection through a receiver tank
or backflow preventer is usually permitted.
Page 8 — English