Reversible Door - La Sommeliere CTPE151A+ Mode D'emploi

GB

Reversible door.

The door can be changed from right-hinged to left-hinged and vice versa as follows:
1. Lay the appliance on its back.
Loosen and remove the upper hinge.
4. Rotate the plinth through 180° and fit it
with the four screws
Fit the lock cylinder and the lock pin
using a flat-headed screwdriver.
6 After reversing the door, it is important to check that the sealing strip provides a tight seal all the way round. If it does not, carefully
heat the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet.
Be careful not to heat the strip so much that it melts!
The door can be adjusted using the upper hinge and the bottom pin.
Because the appliance has been laid down it must be allowed to stabilise in an upright position for at least an hour before being
switched on.
2. Move the door up slightly
Unscrew the lock pin using a flat-headed
screwdriver. (1)
Unscrew the bottom pin and fit it on the
opposite side in the same position as
before (2)
5. Fit the door onto the bottom pin, fit the
top hinge and tighten securely.
Be aware that the door is mounted right
and proper before the cabinet being
braught to an uprigtht position.
8
3. Pull out the lock (1)
Unscrew the plinth. Four screws - two
on each side (2)
Carefully remove the plinth using a
flat-headed screwdriver. (3)