Getting Started; System Settings - auna multimedia IR-140 Mode D'emploi

Main menu
The following modes can be selected in the main menu: Internet radio, Music player, DAB radio, FM radio, AUX in,
Sleep, Alarms, System settings. To select your desired function, rotate the SELECT control followed by pressing on it
to confirm.
Set up wizard
The setup wizard is available in the system settings section, you can run through this to configure settings for date/
time and network, once this has finished, your radio is ready to use. Note: No need to run through the setup wizard if
a wired network is used.
•
12/24 hour display
To select your preference between 12 or 24 hour clock display format - rotate the SELECT control followed by
pressing on it to confirm.
•
Time/Date
The time and date can be manually set or automatically via the network, DAB or FM.
Auto update
The auto update works with data sent over DAB, FM or the Internet. The clock is only updated when in a correspon-
ding mode, so it is recommended to select a mode that you use regularly.
• Select auto update from DAB, FM or Network.
• Select the appropriate time zone if the auto update is done by the Internet.
• If your country uses daylight saving, the automatically update time may be wrong by one hour. Set th daylight
savings to ON when daylight savings are in effect.
Manual set
• If "No update" is selected, the wizard will prompt you to set the time and date manually. The date and time are
displayed in dd-mm-yyyy and hh:mm AM/PM format.
• The value to be set will flash, rotate the SELECT control to adjus the value followed by pressing on it to go for
the next setting, firs set the date then finally the time.
• Network
The unit is compatible to all standard network protocols and encryption methods, including Wi-Fi Protected Setup
(WPS). In case of an unencrypted network, the unit will automatically establish connection and no further settings
are necessary.
Standard encrypted network
• To enter the network key (password), rotate the SELECT control to move the cursor through the characters to
be selected and press on it to confirm.
• The key that is entered will be displayed in the upper part of the display.
WPS-encrypted network
WPS-encrypted networks are identified by their network names as soon as the unit starts searching for available
network connection. Select one of the following connection methods:
• Push button: The radio prompts you to press the connection button on the router, it then scans for a corre-
sponding network and establishes the connection.
• Pin (code number): The radio generates an 8-digit code number. Enter this code number into the wireless
router or access device.
• WPS: Enter the network key for a standard encrypted network.

Getting Started

System settings

18