auna multimedia IR-140 Mode D'emploi page 17

Button Function
When playing, standby after a set time.
SLEEP/SNOOZE
When alarm is sounding, snooze for a set time.
Press for the Preset recall/Save menu, Scroll up/down to select the preset number then press
MEMORY
Select to confirm.
On unit, Turn to scroll through a menu or station list. The chosen option is highlighted in reverse
SCROLL/SELECT
text(white characters on a dark background). Press to select.
Press to previous track or hold to scan down/rewind.
Press to next track or hold to scan up/fast forward.
Play / Pause
VOL- Decrease volume
VOL+ Increase Volume
MUTE Mute audio output
Press to scroll up through a menu or station list.
Press to scroll down through a menu or station list.
Press to scroll back.
Press to scroll forward.
SELECT Select the chosen option.
Mains Connection
• Connect the AC power cord to the unit via the AC socket at the back.
• Plug the AC power cord to the AC mains outlet.
Wired Network Connection
• Check first of all whether the control lamps (LINK/ACT) of your LAN connection or your router light up.
• Use an Ethernet cable with RJ45 connector to connect the NETWORK socket of the radio with the LAN port of your
router.
• Proceed for the operation as described in the below "GETTING STARTED". But no need to run through the setup
wizard Note:Information on the LAN connection can be obtained from the user manual of the router manufacturer.
Wireless Network Connection
• Check first of all whether the control lamps (LINK/ACT) of your WLAN connection or your router light up.
• Proceed for the operation as described in the below "GETTING STARTED". It is highly recommended to run through
the setup wizard in the system settings section.
• Note:Information on the WLAN/WiFi network connection can be obtained from the user manual of the router ma-
nufacturer. Walls or other obstacles may influence the WiFi range. Try to find the best location to avoid interruption
and interference while operating.
Press the POWER button once to switch on the radio, the display will show the main menu. To go to a function or open
a sub-menu, rotate the SELECT control followed by pressing on it to confirm. Each function is selected via a menu
consisting of several levels.
Setup & Connections
17